- Industrie: Energy
- Number of terms: 18450
- Number of blossaries: 0
- Company Profile:
A system of pipes for transporting gas within a distributing gas utility's retail service area to points of connection with consumer service pipes.
Industry:Energy
The range from base load to a point between base load and peak. This point may be the midpoint, a percent of the peak load, or the load over a specified time period.
Industry:Energy
Mechanical mixing of motor gasoline blending components, and oxygenates when required, to produce finished motor gasoline. Finished motor gasoline may be further mixed with other motor gasoline blending components or oxygenates, resulting in increased volumes of finished motor gasoline and/or changes in the formulation of finished motor gasoline (e.g., conventional motor gasoline mixed with MTBE to produce oxygenated motor gasoline).
Industry:Energy
The amount of heat energy available to be released by the transformation or use of a specified physical unit of an energy form (e.g., a ton of coal, a barrel of oil, a kilowatthour of electricity, a cubic foot of natural gas, or a pound of steam). The amount of heat energy is commonly expressed in British thermal units(Btu). Note: Heat content of combustible energy forms can be expressed in terms of either gross heat content (higher or upper heating value) or net heat content (lower heating value), depending upon whether or not the available heat energy includes or excludes the energy used to vaporize water (contained in the original energy form or created during the combustion process). The Energy Information Administration typically uses gross heat content values.
Industry:Energy
That portion of operating expenses consisting of labor, materials, and other direct and indirect expenses incurred for preserving the operating efficiency and/or physical condition of utility plants used for power production, transmission, and distribution of energy.
Industry:Energy
An electric generating plant with output controlled by the natural variability of the energy resource rather than dispatched based on system requirements. Intermittent output usually results from the direct, non-stored conversion of naturally occurring energy fluxes such as solar energy, wind energy, or the energy offree-flowing rivers (that is, run-of-river hydroelectricity).
Industry:Energy
Naphthas (e.g., straight-run gasoline, alkylate, reformate, benzene, toluene, xylene) used for blending or compounding into finished motor gasoline. These components include reformulated gasoline blend stock for oxygenate blending (RBOB) but exclude oxygenates (alcohols, ethers), butane, and pentanes plus. Note Oxygenates are reported as individual components and are included in the total for other hydrocarbons, hydrogens, and oxygenates.
Industry:Energy
Heating and/or cooling equipment that,during the heating season, draws heat into a building from outside and, during the cooling season, ejects heat from the building to the outside. Heat pumps are vapor-compression refrigeration systems whose indoor/outdoor coils are used reversibly as condensers or evaporators, depending on the need for heating or cooling.
Industry:Energy
The cost of labor, material, and expenses incurred in the maintenance of a steam plant. Includes furnaces; boilers; coal, ash-handling, and coal-preparation equipment; steam and feed water piping; and boiler apparatus and accessories used in the production of steam, mercury, or other vapor to be used primarily for generating electricity. The point at which an electric steam plant is distinguished from an electric plant is defined as follows:
1. Inlet flange of throttle valve on prime mover.
2. Flange of all steam extraction lines on prime mover.
3. Hot well pump outlet on condensate lines.
4. Inlet flange of all turbine-room auxiliaries.
5. Connection to line side of motor starter for all boiler-plant equipment.
Industry:Energy
A solar thermal collector in which incident solar radiation is absorbed by the storage medium.
Industry:Energy
